|
1. DIMENSIONS
|
|
| Vehicle length |
10.300 mm
|
| Optional |
9.000 / 11.600 mm
|
| Wheelbase |
6.300 mm
|
| Optional |
5.000 / 7.600 mm
|
| Front overhang |
2.400 mm
|
| Rear overhang |
1.600 mm
|
| Roof height |
3.000 mm
|
| Turning circle |
23.900 mm
|
| Width |
2.500 mm
|
| Angle of approach |
8 degree
|
| Angle of departure |
8 degree
|
| Width of door 1 |
1.065 mm
|
| Width of door 2 |
1.290 mm
|
| Floor height door 1 |
320 mm
|
| Floor height door 2 |
320 mm
|
|
Capacity
|
|
| Number of seats |
25 + 1
|
| Number of standees with max. number of seats |
34
|
|
Weight
|
|
| Total weight, empty vehicle |
approx. 7.600 kg
|
| Front axle load max. |
4.650 kg
|
| Rear axle load max. |
8.800 kg
|
|
2. CONSTRUCTION INTEGRAL
|
| Two aluminium sandwich panels, one as roof and one as floor. Both joined by a GRP C-shaped module which also serves as side wall. |
|
3. DRIVELINE
|
| The engine and generator are assembled as a single unit. This unit can easily be nstalled/removed from the engine compartment at the rear of the bus. The generator charges the batteries. An electric motor is mounted on the rear axle and powered by the batteries. When braking the electric motor acts as a retarder and this energy is returned to the batteries. |
|
Engine
|
|
| Vertical in rear |
VW 1,9 TD, 4 stroke 4 cyl. diesel
45 kW at 3000 min -1 |
|
Generator
|
| Permanent-magnet generator with an output of 40 kW |
|
Batteries
|
| 27 x 12 V batteries |
|
Electric motor
|
| Water-cooled electric motor with a nominal rating of 55 kW and a peak output of 110 kW (during acceleration) |
|
Axles / brakes
|
|
| Front |
Independent suspension / disc brakes
|
| Rear |
A-frame with Panhard rod / disc brakes
|
| Redarder |
110 kW
|
| Tyres |
245/70 R17,5"x134/132L
|
|
Fuel tank
|
|
| Capacity |
120 L
|
|
4. EXTERIOR OF VEHICLE
|
|
Exterior
|
| Aluminium sandwich roof Side wall panels in polyester, bonded to construction Skirt panels in polyester Front and rear sections in polyester Bumpers in polyester Service doors in aluminium |
|
Glazing
|
| Windscreen of single-curvature laminated glass Driver's window, single sliding Side windows single, tinted, safety glass |
|
Doors
|
| Door 1 single out swing with electric-pneumatic drive Door 2 double sliding door with electric-pneumatic drive and jamming device |
|
5. INTERIOR EQUIPMENT
|
|
Floor
|
| Floor consisting of aluminium sandwich panel Floor covering with anti slip protection, Altro or alternative Floor hatches where necessary Wheel casing in polyester |
|
Interior lighting
|
| Fluorescent lights 2x4 either side of ceiling Cabin light Light above each door |
|
Seats
|
| Door 1 single out swing with electric-pneumatic drive Door 2 double sliding door with electric-pneumatic drive and jamming device |
|
6. HEATING / VENTILATION
|
|
Driver's compartment
|
| Heating/ventilation system with outside air intake at roof level, air-filter and electronic control Air-conditioning (optional) |
|
Passenger area
|
| Interior heating/ventilation by units located under seats (recirculation) and in roof (outside air), automatic controlled Webasto thermo 300 water heater Air-conditioning (optional) |
|
7. ELECTRICAL SYSTEM
|
|
Electrical system: 24V
VDO instrument panel Central panel with Multiplex system CAN J1939 in front |
|
8. ROUTE AND DESTINATION EQUIPMENT
|
|
Possibilities for mounting front, side and rear
|
|
9. COMPRESSED AIR SYSTEM
|
|
Workshop air-connection at entrance
Two pressure gauges and low-pressure alarm Parking brake and door brake |
|
10. CONTROL SYSTEM
|
|
Anti locking system by WABCO-ABS
Suspension control by WABCO-ECAS Traction control by WABCO-ASR (Optional) |
|
|
|